THE INTERNET TECHNOLOGY TRAINERS
MIMIC® Cisco Virtual Lab Cloud (Online) for CCNA / CCNP Certification
Device Operations:
- Loggin-in/out
- Get into and out of different modes - User, Privileged, Configuration, Interface
- Set passwords, IP addresses, clock rates, hostname, bandwidth
- Assign routing protocols - RIP, IGRP, EIGRP, BGP, OSPF, IS-IS
- Configure IPv4 or IPv6 addresses
- VLAN configuration; Rapid-PVST configuration
- Ping/Telnet other devices in the lab
- Save/load/reload configuration using flash or TFTP protocol
- Configuration of ISDN, CDP, PPP, Frame Relay ACL and NAT protocols
- Save the configuration at a good point & start over many times as desired
- Troubleshoot by retracing the commands from the log
- Context sensitive help
- ... and many other functions required for certification. See full web version of the page for
Supported platforms:
- Windows (any)
- Solaris
- Linux
- MAC
The Lab Features:
Interact with the routers and switches, just like real devices:
- Network of 7 devices
- Cisco Routers (2811, 3640 and 7206)
- Four Cisco Switches (2950, 3550 (2) and 6500)
- A large set of IOS Commands for Router and Switch operations
- LAN, WAN, ISDN and Serial links
- Ability to Reconfigure the lab
- Exercise the lab using ready scenarios
- Users can Telnet in to any of these devices as if they are connecting to real devices. You can open as many Telnet connections as the device supports. Users can also connect to it using a Console connection. It fully supports Cisco IOS® software.